1. Cut track to desired length
Cut track to desired length to fit the location for the Roll Control brackets and other accessories in boat or van.
2. Remove burrs
Remove all burrs from exposed ends with a file and radius front edges (Fig. A)
3. Drill and countersink holes
Drill and countersink holes for 1/4″ flat head bolt 1-1/4″ from the end of the track (Fig. B). Screw heads must be flush or below surface of track.
Additional notes:
Track may be mounted flush to surface (Fig. C) or spaced with Roll Control Mounting Kit to match horizontal or vertical angle of surface (Figs. D & E). Be sure to allow adequate room at end of track to allow Roll Control brackets, rod holders and other accessories to slide in.
